What is the compressibility of liquid brainly

Tables

Reference
Sears, et al

You can observe a real-life application of Boyle's Law when you fill your bike tires with air. When you pump air into a tire, the gas molecules inside the tire get compressed and packed closer together. This increases the pressure of the gas, and it starts to push against the walls of the tire. You can feel how the tire becomes pressurized and tighter. Another example is a soda bottle. To get carbon dioxide gas into the liquid, the whole bottle is usually pressurized with gas. As long as the bottle is closed, it is very hard to squeeze, as the gas is confined to a small space and pushes against the bottle's walls. When you remove the cap, however, the available volume increases and some of the gas escapes. At the same time its pressure decreases.

One important demonstration of Boyle's law is our own breathing. Inhaling and exhaling basically means increasing and decreasing the volume of our chest cavity. This creates low pressure and high pressure in our lungs, resulting in air getting sucked into our lungs and leaving our lungs. In this activity you will create your own demonstration of Boyle's law.

Materials

• At least two small balloons such as water balloons
• Large plastic syringe (approximately 60 milliliters works well), such as a children's oral medicine syringe (available at most drug stores). Ensure that it is airtight and does not have a needle.
• Scissors
• Water

Preparation

• Use the syringe to fill one balloon with a little bit of air—so that the balloon will still fit inside of the syringe. Tie off the balloon and trim any extra balloon material beyond the knot.
• Fill the syringe with water.
• Use the syringe to fill another balloon with some of the water, making it the same size as the air-filled balloon. Tie its opening with a knot, and trim any remaining material after the knot.
• Remove the plunger from the syringe so that it is open on the large end.

Procedure

• Place the air-filled balloon just inside the large opening at the back of the syringe. Insert the plunger into the syringe, and try to push the balloon into the tip of the syringe. How hard is it to push the plunger in? What happens to the air inside the syringe?
• Pull the plunger back again, and move the balloon into the middle of the syringe. Then close the front opening (the tip) of the syringe with one finger, and push the plunger into the syringe again. What do you notice? How does the balloon look or change when you push the plunger in?
• Release your finger from the tip of the syringe. Place the balloon into the tip of the syringe, and push the plunger into the syringe until it touches the balloon. Then close the tip of the syringe with your finger and pull the plunger all the way back. Does the balloon shape change? If yes, how? Can you explain why?
• Replace the air-filled balloon inside the syringe with the water-filled balloon. Then place the plunger into the syringe. Close the tip of the syringe with your finger, and push the plunger into the syringe as far as you can. How does the balloon change this time?
• Release your finger from the tip of the syringe, and push the plunger all the way into the syringe until it touches the balloon at the tip of the syringe. Then close the tip of the syringe again with your finger, and try to pull the plunger back as far as you can. What happens to the water-filled balloon? Does it behave differently than the air-filled balloon? If yes, how and why?
• Extra: Use the same setup, but this time add water to your syringe in addition to the air-filled and water-filled balloons. Then close the tip of the syringe and try to press the plunger into the syringe and pull it out again. What happens this time? How does the water inside the syringe make a difference?

Observations and Results
Did you see the air inside the air-filled balloon contract and expand? Without closing the tip of the syringe with your finger, you can easily push on the plunger. The air can escape through the opening at the tip of the syringe. But when you close the syringe with your finger the air can't escape anymore. If you press on the plunger, you increase the pressure of the air and thus the air in the balloon contracts or decreases its volume. You should have seen the air-filled balloon shrivel up and get smaller in size. The opposite happens when you close the opening of the syringe and pull the plunger back. This time you decrease the pressure of the air inside the syringe—and its volume increases. As a result the air-filled balloon expands and grows in size: a perfect demonstration of Boyle's law!

The results look different with the water-filled balloon. Although you are compressing the air inside the syringe when pressing on the plunger, the water inside the balloon does not get compressed. The balloon stays the same size. The water balloon also keeps its shape when pulling out the plunger while closing the tip of the syringe. In contrast to gases, liquids are not compressible as their particles are already very close together. Boyle's law only applies to gases.

If you filled the syringe with water as well, you should still have seen the air-filled balloon shrinking while pushing the plunger into the syringe. The air-filled balloon also should have expanded when pulling the plunger out while the tip of the syringe was closed. You might have noticed, though, that you were not able to push and pull the plunger in and out as far as you could with the air-filled syringe. This is again because of the fact that liquids cannot be compressed like gases. You should have observed that also when trying to push the plunger in or pull it back in the water-filled syringe with the water-filled balloon. It was probably impossible to move the plunger in and out!

What is the compressibility of liquid?

What is the compressibility of solid liquid and gas?

Is liquid compressible Class 9?

What is compressibility Brainly?